Hotpoint WMEF 722 BC UK Bedienungsanleitung PDF herunterladen (Seite 2)

2

GB

Installation

(see figure); the angle of inclination, measured

according to the worktop, must not exceed 2°.

Levelling your appliance correctly will provide

it with stability and avoid any vibrations, noise

and shifting during operation. If it is placed on

a fitted or loose carpet, adjust the feet in such

a way as to allow enough room for ventilation

beneath the washing machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the supply

pipe to the water

mains using a gas 3/4

attachment, fitting the

rubber gasket and

the filter supplied with

the appliance and

ensuring that they are

fimly tightened to the

taps. The water supply

marked C must be connected to the cold water

tap; the pipe marked H must be connected

to the hot water tap (max. temperature 60°C).

Both pipes may be connected to the cold water

tap using the special Y connection with multiple

attachments, supplied with the appliance (see

figure). Before making the connection, allow the

water to run freely until it is perfectly clear.

2. Connect the inlet

hose to the machine

by screwing it onto

the cold water inlet of

the appliance, which

is situated on the top

right-hand side of the

rear part of the appliance

(see figure).

3. Make sure there are

no kinks or bends in the hose.

! The water pressure at the tap must be within

the values indicated in the Technical details

table (on the page 5).

! If the water inlet hose is not long enough,

contact a specialist store or an authorised

serviceman.

! Ensure that the supply taps are allowing

water through. Old taps may seize in the

closed position and thus prevent water

reaching the machine.

! Never use second-hand or old inlet hoses;

use the products supplied with the machine.

! Keep this instruction manual in a safe place

for future reference. Should the appliance be

sold, transferred or moved, make sure the

instruction manual accompanies the washing

machine to inform the new owner as to its

operation and features.

! Read these instructions carefully: they contain

vital information on installation, use and safety.

Unpacking and levelling

Unpacking

! This is a separate

part of the polystyrene

base and should be

removed with the

base.

! IMPORTANT check

when unpacking

your machine.

1. Unpack the washing machine.

2. Check whether the washing machine has

been damaged during transport. If this is the

case, do not install it and contact your retailer.

3. Remove the 4

protective screws and

the rubber bush with

the respective spacer,

situated on the rear of

the appliance (see also

the installation leaflet).

4. Seal the gaps

using the plastic plugs

provided.

5. Keep all the parts:

you will need them again if the washing machine

needs to be moved to another location.

! Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable

amount of noise if the two front feet have not

been adjusted correctly.

1. Install the washing

machine on a flat sturdy

floor, without resting it up

against walls, cabinets or

anything else.

2. If the floor is

not perfectly level,

compensate for

any unevenness by

tightening or loosening

the adjustable front feet

1 2 3 4 5 6 7 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare