Hotpoint DDP-700 Bedienungsanleitung PDF herunterladen (Seite 8)

MODEL NAME

DDP-700

USER GUIDE

PAGE

INSTALLATION DO’s AND DONT’s

Charging the batteries

Your DDP-700 handset need battery to operate. During the first use of your DDP-700, it is recommended that the

handset is left over on charge overnight to ensure maximum in-use time.

1. Only use the rechargeable batteries supplied with your DDP-700

2. Install the rechargeable batteries into the rear of your handset. MAKE SURE you insert the batteries in correct

polarity.

3. Position the battery cover over the rear of the handset and slide into place.

4. Place the handset on the base unit to charge.

5. The handset will beep and the red LED CHARGE light on the base unit.

NOTE :

If the charge do not light up, reposition the handset in the base unit ensuring the charging points contact.

Electrical Safety

1. DO NOT install the base unit near a sink, bath or shower or anywhere else where it could get wet. Electrical

equipment can cause serious injury if used while you are wet or standing on water.

2. If the base unit ever falls into water, DO NOT retrieve it until you have unplugged the AC mains power adaptor and

the telephone line plug from the telephone wall socket.

3. DO NOT allow the handset to come in contact with water

4. DO NOT open the handset or the base.

5. DO NOT allow the charging contacts or the battery to come in contact with electrical conductive materials such

as metals, rings, paper clip, key, etc.

6. MAKE SURE you insert the batteries in correct polarity.

7. NEVER USE your DDP-700 in the open air during a thunderstorm - unplug the base unit from the telephone line

and the AC mains socket where there are storms in your area. Damage caused by lighting may likely to

happen.

8. If your DDP-700 is not to be used for long period of time, disconnect the main AC power adaptor from the AC

power socket and the telephone line from the telephone wall socket

Emergency calls

Your DDP-700 need mains power. So you cannot use for plac-

ing a call during AC power failure.

Thus, a basic phone that does not need AC mains power is

needed to place an emergency call during power failure.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 57 58

Keine Kommentare

Hotpoint DDP-700 Bedienungsanleitung Seite 8