Hotpoint CH60DHWF S Bedienungsanleitung PDF herunterladen (Seite 8)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

INSTALLATION INSTRUCTIONS

SPACE FOR FIXING

The cooker can be close fitted below hotplate level. This requires a minimum distance of 600mm between cupboard

units of hotplate height.

When installing next to a tall cupboard, partition or wall, for a minimum distance of 400mm above hotplate level,

allow a side clearance of at least 65mm.

The diagram below illustrates the minimum clearance between the cooker and adjacent walls, cupboards etc.

The wall behind the cooker, 50mm below and 450mm above, and the width of the cooker, must be a non-

combustible material such as ceramic wall tiles.

If the cooker is to be fitted close to a corner on the left hand side, ensure that there is a clearance of at least 50mm

to allow the main oven door to open fully for when removing oven shelves.

65 mm Min

840 mm Min

400 mm Min

600 mm Min

750mm Min

COOKER HOODS

If a cooker hood is to be installed, refer to the cooker hood manufacturers' instructions regarding fixing height.

UNPACKING THE COOKER

Unpack the components from inside the grill and oven. Check that the following parts are present:

Grill pan and grid Main oven shelves (2)

Top oven/grill shelf (1) Pan supports

Baking dish Enamelled burner caps (4)

Aluminium burner bodies (4) Literature

LEVELLING

Four skid feet are fitted which can be adjusted up or down to level the cooker.

CONVERSION FOR USE ON BUTANE (G30) OR PROPANE (G31)

Each burner requires the injector to be replaced and bypass screws adjusted or replaced as follows:

1. Remove the loose hotplate burner parts.

2. Using a 7mm socket, replace the hotplate injectors as appropriate (see table on previous page).

3. Re-position the loose burner parts.

4. Carefully pull off the hotplate control knobs.

5. Using a narrow flat bladed screwdriver rotate the bypass screws fully clockwise. The hotplate tap bypass

screws are located down the centre of the spindle.

6. Re-assemble the control panel parts.

7. Secure the self-adhesive LPG conversion label over the gas details on the data badge.

The appliance must not be installed behind

a decorative door in order to avoid overheating

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Keine Kommentare

Hotpoint CH60DHWF S Bedienungsanleitung Seite 8