Hotpoint HSWP1000MWW Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 10)

Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips

Before you call for service…

WATER Possible Causes What To Do

Too many suds Too much detergent • Measure your detergent carefully. Use less soap if you have

soft water, a smaller load or a lightly soiled load.

Type of detergent • Switch to a lower sudsing detergent brand and follow

instructions on package.

Soft water • Try less detergent.

Water leaks Using too much detergent • Use less detergent. Use less soap if you have soft water,

in washer a smaller load or a lightly soiled load.

Fill hoses or drain hose is • Make sure hose connections are tight at faucets and

improperly connected rubber washers are installed. Make sure end of drain hose

is correctly inserted in and secured to drain facility.

Household drain may • Check household plumbing. You may need to call

be clogged a plumber.

Drain hose loose • Make sure drain hose is fully seated in back of washer and

that the two retaining screws are fully seated.

Drain hose rubs on wall • Make sure drain hose does not make contact with the wall.

May cause excessive wear on the hose.

Constant water pressure • Tighten hoses at the faucets and turn the water off after

to the fill hoses at the each use.

water source

• Check condition of the fill hoses; they should be replaced

every 5 years.

Water temperature Cooler water temperatures • New laundry detergents have been formulated to work

seems incorrect provide improved energy with cooler water temperatures without affecting wash

efficiency performance.

Water supply is turned off • Turn both hot and cold faucets fully on and make sure

or improperly connected hoses are connected to correct faucets.

Water valve screens are • Turn off the water source and remove the water connection

stopped up hoses from the upper back of the washer. Use a brush or

toothpick to clean the screens in the machine. Reconnect

the hoses and turn the water back on.

House water heater is • Make sure house water heater is delivering water at

not set properly 120°F–140°F (48°C–60°C).

Water pumped out before Lid lifted or cycle was put in • Reset cycle.

cycle is complete pause for over 24 hours

Water won’t drain Drain hose is kinked or • Straighten drain hose and make sure washer is not

improperly connected sitting on it.

• Top of drain outlet should be less than 6 ft (1.8 m)

above floor.

Washer pauses during This is normal • This is normal. The washer alternates between agitate and

wash cycle soak during some wash cycles to get your clothes cleaner with

less wear.

Washer pauses during This is normal • The washer may pause during the spin cycle to remove

spin cycle soapy water more efficiently.

Troubleshooting Tips

Save time and money! Review the charts on the following pages,

or visit www.Hotpoint.com. You may not need to call for service.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Hotpoint HSWP1000MWW Gebrauchs- und Pflegehandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Waschmaschinen Hotpoint HSWP1000MWW